How to use the gravel calculator
- Measure the length and width of the area in feet. For odd shapes, split it into rectangles and add the results.
- Enter the depth of gravel you want in inches.
- Leave the weight at 1.4 tons per cubic yard unless your supplier gives you a different figure.
- Add the price per ton from your supplier to see an estimated cost.
Formula
Volume (cu ft) = length (ft) × width (ft) × depth (in) ÷ 12
Cubic yards = cubic feet ÷ 27
Tons = cubic yards × weight per cubic yard (about 1.4 tons for typical gravel)
Worked example
A 20 × 10 ft path covered 3 inches deep holds 50 cubic feet of gravel, which is 1.85 cubic yards. At 1.4 tons per cubic yard that is about 2.59 tons.
Tips before you buy
- Typical gravel weighs about 1.3–1.5 tons per cubic yard depending on the stone and how wet it is. Ask your supplier for their figure.
- Gravel compacts. If you will run a plate compactor over it, order around 10–15% more than the finished depth suggests.
- Paths and patio bases are commonly 2–4 inches deep; driveways usually need a thicker, layered base.
- Lay landscape fabric first to slow weeds and stop gravel sinking into soft soil.
Frequently asked questions
How many square feet does a ton of gravel cover?
At 1.4 tons per cubic yard, one ton covers about 231 square feet at 1 inch deep, about 116 square feet at 2 inches, and about 77 square feet at 3 inches.
How much does a cubic yard of gravel weigh?
Usually about 2,600 to 3,000 lb (1.3–1.5 tons), depending on the type of stone and moisture.
How deep should gravel be for a walkway?
Two to three inches is common for walkways. Use more over soft ground or where it will carry heavy loads.
Should I buy gravel by the ton or by the yard?
Either works. Use the calculator to get both numbers, then compare prices from suppliers on the same basis.
Last updated: