How to use the deck calculator
- Enter the deck length along the direction the boards run, and the deck width across them.
- Enter the actual board width (a nominal 6-inch board is 5.5 inches wide) and the gap between boards.
- Pick the board length you will buy and the joist spacing.
- Add 10% waste for cuts and rejected boards.
Formula
Rows of boards = deck width × 12 ÷ (board width + gap), rounded up
Boards = rows × (deck length ÷ board length, rounded up) × (1 + waste)
Joists = deck length × 12 ÷ joist spacing, rounded down, + 1
Screws = rows × joists × 2
Worked example
A 16 × 12 ft deck with 5.5 inch boards and a 1/8 inch gap needs 26 rows. Using 16 ft boards, that is one board per row, so with 10% waste you buy 29 boards. At 16 inches on center there are 13 joists, and fastening two screws per joist crossing takes 676 screws.
Tips before you buy
- Buy board lengths that span the deck in one piece when you can. It looks better and wastes less.
- Composite and PVC decking often need closer joist spacing. Follow the manufacturer’s installation guide.
- Joist size depends on span and spacing. Use a span table or ask your local building department.
- Hidden fastener systems use clips instead of face screws. Swap the screw count for the clip count on the box.
Frequently asked questions
How many deck boards do I need for a 12×16 deck?
With 5.5 inch boards, a 1/8 inch gap and 16 ft boards running the long way, you need 26 boards, or 29 with 10% waste.
What is the actual width of a 2×6 or 5/4×6 deck board?
Both are 5.5 inches wide.
How many screws do I need for a deck?
Two screws at every place a board crosses a joist. With 5.5 inch boards that is roughly 320 screws per 100 square feet at 16 inch joist spacing.
What gap should I leave between deck boards?
About 1/8 to 3/16 inch is common for kiln-dried boards. Wet pressure-treated boards are often butted tight because they shrink.
Last updated: